Palax Active TR/TR, Инструкция по эксплуатации

Страница: 27 / 44

27
Palax D270 Active Translation 1-2017
Cutting small trees

Ensure that the log is travelling at the rear edge of the in-feed deck.

Only cut one log at a time.

Make sure that the last log to be cut is kept firmly in position under the clamp during sawing.
4.5. Lubricating the chain-saw

The machine is equipped with an automatic lubricator for applying saw-chain oil.

The machine is equipped with a hydraulically controlled piston pump with adjustable, precise
metering.
NOTE ! The volume of oil applied at each pass is sufficient by a fair margin to lubricate the
chain under normal conditions. If you cut a lot of thick trees, it advisable to increase
the oil volume. Temporarily, the oil volume can be increased by lifting up the
crosscut saw-bar and, immediately after that, resuming the operation.
4.6. Adjusting the oil feeding rate
NOTE ! Always switch off the machine before
adjusting the oil flow.

The adjustment screw (6-mm hexagon
socket) (Fig. 4.3 A) is located in the machine's
frame, above the chain oil tank.

The correct adjustment directions are shown
on the decal affixed to the machine (Fig. 4.3
B). The oil flow is increased by turning the
screw counter-clockwise, and it is decreased
by turning it clockwise.

The basic setting of the screw is 1-2 turns in
the open direction.

Twisting the adjustment screw by one turn
increases or reduces the oil rate by about 0.1 millilitres.

If you see air in the suction hose of the oil pump or the oil pump has sucked air, check that the
suction hose is immersed in the oil , turn the setting of the pump (several turns) in the plus-
direction, and execute a few sawing movements. In this way, air will be more efficiently
removed from the pump, and the oil supply to the saw will remain constant. After this,
remember to turn the oil flow adjustment screw back to its initial setting.
4.3
A B