Palax Active TR/TR, Инструкция по эксплуатации

Страница: 19 / 44

19
Palax D270 Active Translation 1-2017
2.8. Height adjustment of splitting wedge (option)

The lever for adjusting the height is included in the delivery of the 2/4 splitting wedge. Fig. 2.7
2.14
2.15
A
2.16
A
B
C
D
2.17
A

Installing the lever: Remove the attachment screw of the splitting wedge and lift away the used
wedge. Fig. 2.15. A. Parts of the lever, Fig. 2.16; Friction plate A, Spring washers B, Attachment
nut C, Safety cotter D.

Remove the cotter and twist open the nut; remove the spring washers. Lift the 2/4 wedge in
place, and after this, install the height adjustment lever into position leaving the friction plate
between the lever and the frame, Fig 2.17A. Place the pin at the end of the lever in the slot at
the lower end of the splitting wedge.
2.18 2.19
A

Place the spring washers face-to-face between the attachment screw of the adjustment lever
and the frame before twisting the nut into position, as shown in Fig. 2.18. Wrench the nut
suitably tight so that the splitting wedge will move when the lever is being pulled. After this,
insert the cotter in the hole in the bolt.