paladin JRB SMART-LOC, Руководство оператора

Страница: 9 / 31

9
OM90A
EQUIPMENT SAFETY PRECAUTIONS
WARNING! KNOW WHERE UTILITIES ARE
Observe overhead electrical and other utility lines. Be sure equipment will clear
them. When digging, call your local utilities for locqtion of buried utility lines, gas,
water, and sewer, as well as any other hazard you may encounter.
WARNING! EXPOSURE TO RESPIRABLE CRYSTALLINE SILICA DUST
ALONG WITH OTHER HAZARDOUS DUSTS MAY CAUSE
SERIOUS OR FATAL RESPIRATORY DISEASE.
It is recommended to use dust suppression, dust collection and if necessary
personal protective equipment during the operation of any attachment that may
cause high levels of dust.
WARNING! REMOVE PAINT BEFORE WELDING OR HEATING
Hazardous fumes/dust can be generated when paint is heated by welding, soldering
or using a torch. Do all work outside or in a well ventilated area, and dispose of paint
and solvent properly. Remove paint before welding or heating.
When sanding or grinding paint, avoid breathing the dust. Wear an approved respira-
tor. If you use solvent or paint stripper, remove stripper with soap and water before
welding. Remove solvent or paint stripper containers and other flammable material
from area. Allow fumes to disperse at least 15 minutes before welding or heating.
WARNING! END OF LIFE DISPOSAL
At the completion of the useful life of the unit, drain all fluids and dismantle by sepa -
rating the different materials (rubber, steel, plastic, etc.). Follow all federal, state and
local regulations for recycling and disposal of the fluid and components.
OPERATING THE ATTACHMENT
• Never use your attachment for a work platform or personnel carrier.
• Do not exceed the lifting capacity of your prime mover.
• Operate only from the operator’s station.
• When operating on slopes, drive up and down, not across. Avoid steep hillside op-
eration, which could cause the prime mover to overturn.
• Reduce speed when driving over rough terrain, on a slope, or turning, to avoid over-
turning the vehicle.
• An operator must not use drugs or alcohol, which can change his or her alertness or
coordination. An operator taking prescription or over-the-counter drugs should seek
medical advice on whether or not he or she can safely operate equipment.
• Never lift, move, or swing a load or attachment over anyone.
• Before exiting the prime mover, lower the attachment to the ground, apply the
brakes, turn off the prime mover’s engine and remove the key.
KEEP ATTACHMENT CLOSE TO THE GROUND DURING ALL
LOCK AND UNLOCK OPERATIONS.
Attachment can drop without warning if not properly secured. Visually check the
coupler is securely locked on attachment. Follow procedures described in this
manual for checking fit between coupler and attachment. Failure to do so could
result in serious injury or death.
WARNING!