paladin FFC PREPARATOR LAF3566, Руководство оператора, Страница: 26 / 31

MR955512
26
CHAIN TENSION ADJUSTMENT
Motor side
1. Shut off engine, remove the key, wait for all moving parts to come to a stop. Relieve all
pressure in the hydraulic lines.
2. Remove drive shields.
3. Check chain to see if adjustment is needed: Remove one link if possible (It may be nec-
essary to add back in 1/2 link). There should be at least 0.25” of movement in the chain.
See Figure #1
MAINTENANCE
4. Loosen the .38” tensioner bolt on the top of the chain case to increase tension.
5. Replace and properly secure the appropriate drive shields.
Brush Drive Side
1. Shut off engine, remove the key, wait for all moving parts to come to a stop. Relieve all
pressure in the hydraulic lines.
2. Remove the brush drive shield.
3. Check chain to see if adjustment is needed: Remove one link if possible (It may be nec-
essary to add back in 1/2 link).
4. Adjust the brush leaving a 0.25” of movement in the chain and a maximum of 0.31”
between the brush and the drum. If there is more than 0.31” between the brush and the
drum, then remove a 1/2 link from the chain. Be sure to adjust both ends of the brush so
it remains parallel to the drum.
5. Replace and properly secure the appropriate drive shields.
FIGURE #1
MEASURE THE COMBINED
CHAIN DEFLECTION
STRAIGHT EDGE