pajunk MultiStim ECO, Инструкция по эксплуатации

Страница: 10 / 19

10
Eng
lish
Starting simulation / PAUSE function
After switching on, the MultiStim ECO is always in PAUSE mode.
You can recognize this by the fact that the LED next to the sti-
mulation button is off, and you do not hear any acoustic signal.
Press the stimulation button to start stimulation. Press it again to
switch the MultiStim ECO back to PAUSE mode.
Important: In PAUSE mode, you can change the stimulation cur-
rent intensity without giving stimulation pulses to the patient.
If the patient circuit is already closed after starting stimulation, the
green stimulation LED blinks in accordance with the frequency in
a 1-Hz rhythm; at the same time, you can hear an acoustic signal
in the same rhythm.
If the patient circuit is still open after starting stimulation, the
green stimulation LED is lit, but there is no acoustic signal, and
the yellow LED next to the unequal sign (
≠
) is also on. As soon
as the circuit is closed and pulses are delivered to the patient, the
yellow
≠
goes out. At the same time, the green stimulation LED
starts blinking and the acoustic signal can be heard.
Setting the volume
When the MultiStim ECO is switched on, a medium volume is set
for the acoustic signal.
You can adjust the volume by pressing the volume button
(medium
·
high
·
low
·
medium
·
high
·
low
·
, etc.). The adjusted
volume is indicated by the three green LEDs above. The left LED
means low, the right means high. The LED of the selected volume
is lit in green.
If the yellow LED of the ≠ symbol is lit during operation and the acoustic signal
can no longer be heard, the set amperage is no longer reached. This might be
due to the following causes:
• No stimulation cable is connected or it is defective
• The electrodes are not or not correctly connected.
• The electrical resistance of the patient's tissue is too high.
The active stimulation can also be ended by pressing the ON/OFF button (keep
the button pressed for at least 2 seconds).