User’s Manual
52
NOTE: Sequence cannot be used in the 4x4 display mode of the 16-channel, and 3x3 mode of the 8-channel DVR.
You can adjust the display dwell time by highlighting the box beside
Interval
and pressing the button. You can
select dwell intervals ranging from 1 second to 1 minute.
Highlight
Event Monitoring On
and press the button. Pressing the button toggles between
On
and
Off
. When
it is
On
, the DVR will display the camera associated with the event when an event occurs.
Highlight the box beside
Resolution
and press the button. You can select from 1280x1024, 1440x900 and 1920x1080
for NTSC video, and 1280x1024, 1440x900 and 1920x1080 (@ 60Hz or 50Hz) for PAL video.
NOTE: When the individual main monitors are connected to the HDMI and VGA connectors for simultaneous
operation, it is recommended to use monitors supported with the same resolution. If monitors unsupported
with the same resolution are connected, video cannot be displayed on the monitor with the resolution
you have set.
Highlight
Fit To Screen
and press the button. Pressing the button toggles between
On
and
Off
. When it is
On
,
the DVR will resize video to fit the main monitor screen.
Spot Monitor
Figure 39: Display – Spot Monitor setup screen.
Highlight the box in the
Channels
column and press the button.
You can define which cameras display sequentially on the Spot Monitor when in the single-screen display format.
Highlighting the box under the
Camera
and pressing the button toggles between On and Off.
You can adjust the display dwell time by highlighting the box under the
Dwell
and pressing the button. You can
select dwell intervals ranging from 1 to 20 seconds.
