Page 8 of 14
MACHINE OPERATION
1) Turn on the brush motor switch (1).
2) Turn on the vacuum motor switch (2).
3) Item (6) is the solution flow indicator. When
the indicator is illuminated, cleaning solution
is flowing. To stop the solution flow raise
lever (3) to the off position.
4) Adjust the flow rate of the cleaning solution
with lever (3). There should be enough
solution to wet the floor uniformly, but not so
much that
it gets past the splash guard.
Remember that the correct solution quantity
depends on the type of floor, the dirt level and
the scrubbing speed.
5) Release the foot pedal and lower the brush
base.
6) Lower the squeegee using lever (4).
7) The brushes turn by pulling on levers (5) until
they touch the handle grip. During the first
few yards of operation, check that the
quantity of the cleaning solution is sufficient to
wet the floor and that the squeegee dries the
floor surface.
8)
OVERFILL PROTECTION
The machine is equipped with a float that stops
the vacuum air flow when the recovery tank is
full. When this occurs, empty the recovery tank
by removing the plug on the drain hose and
empty machine into an approved waste drain.
WARNING:
Use gloves for protection from
contact with dangerous solution.
