OPERATING PROCEDURES
WARNING! For the safe operation of this machine
follow the instructions given in this booklet and the train-
ing given by your supervisor. Failure to do so can result
in personal injury and/or damage to machine and prop-
erty!
DO NOT OPERATE MACHINE IN AN EXPLOSIVE
ENVIRONMENT!
NEVER USE THIS MACHINE TO PICK UP VOLA-
TILE OR EXPLOSIVE MATERIALS!
The model shown in this manual is intended for commer-
cial use.
PREPARATION
To prepare the machine for operation, make sure it is of
correct voltage and properly assembled. If in doubt, ask
your supervisor.
!
If the vacuum is in its upright position (page 6)
, raise
the handle while supporting the vacuum, then slowly
lower the vacuum to the floor.
!
Properly install the filter bag in the vacuum:
Lift
the cover from the machine. The filter bag inlet is de-
signed with a rubber gasket that fits securely over the
bag adapter (page 7) in the cover. First push the filter
bag inlet over the adapter on the cover. Then from the
outside of the cover reach inside the adapter and push
the gasket on the rest of the way. Replace the filter
bag when full.
OPERATION
1. Plug the machine’s power cable into a properly
grounded outlet
(see Grounding Instructions).
2. The foot pedal should be raised to the “BRUSH”
position (page 8) for wide area vacuuming.
3. Adjust the brush height
with the lever located on the
rear of the machine near the floor (page 8).
4. Turn the vacuum switch ON
(rocker switch on
operator’s right, page 7).
5. Turn the brush switch ON
(rocker switch on
operator’s left, page 7)
and begin vacuuming
.
OPERATION WITH TOOLS
Three on-board tools are available for the vacuum: the dust-
ing tool, crevice tool and turbo tool (page 6). Twenty (20)
feet of hose is provided which allows access to rooms with-
out moving the machine.
1. The brush and vacuum switches should be turned
OFF.
2. Depress the foot pedal to the “ACCESSORY” posi-
tion.
3. Remove the rigid portion of the accessory hose
from
its’ storage area in the handle and
attach the tool of
choice.
4. Turn the vacuum switch ON and begin.
Note: The vacuum switch should be OFF when switching
the foot pedal between the accessory and the brush posi-
tions.
MAINTENANCE
ALWAYS turn the brush and vacuum motor switches
OFF and UNPLUG the power cord from the electrical
outlet before doing any clean-up or repairs, and when
the machine is left unattended.
AFTER EACH USE:
1. Vacuum filter bag:
If the bag is full or damaged in-
stall a new one.
Filter Bag, 10 Pack – Part Number 650602
Cloth Bag (optional) – Part Number 650601
2. Power cord and plug:
Check for cuts or nicks; if
damaged, have the cord replaced at a factory autho-
rized service center.
3. Casters and Wheels:
Remove any strings or debris
that may restrict the free movement of the casters.
4. Tools:
Inspect the tools to ensure there is no obstruc-
tion of airflow. Remove any debris found.
5. Brush:
Remove any strings or debris. Replace if be-
comes worn or damaged.
Storage:
The handle may be folded down and the
machine stored upright to reduce storage space require-
ments. Store the machine in a clean dry area.
4
