Page 9
SKU 97553
For technical questions, please call 1-800-444-3353.
basic sPeciFicatiOns
Fuel
Type
86+ octane unleaded
gasoline
Capacity
.95 Gallons
Engine Oil
Type SAE 10W 30 above 32° F
5W30 at 32° F or below
Capacity
.63 Quarts
Pump Oil
16.9 oz. SAE 75W90
Engine Speed
3,600 RPM
Engine Family
6CGP.2702GA
Tire Inflation
30 PSI (cold)
Water Flow
4 GPM
Maximum Pressure
3,200 PSI
note:
Additional specifications found in
the TECHNICAL ENGINE SPECIFI-
CATIONS chart in this manual.
The emission control system for this
engine is warranted for standards set by
the U.S. Environmental Protection Agency
and by the California Air Resources Board
(also known as CARB). For warranty
information, refer to the last pages of this
manual.
At high altitudes, the engine’s carbu-
retor, governor (if so equipped), and any
other parts that control the fuel-air ratio will
need to be adjusted by a qualified me
-
chanic to allow efficient high-altitude use
and to prevent damage to the engine and
any other devices used with this product.
unPacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
set uP instructiOns
read the entire iMPOrtant
saFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
risk of accidental
starting; resulting
in serious personal injury.
turn the Power switch of the
equipment to its “OFF”
position, wait for the engine to
cool, and unplug the spark
plug wire(s) before
assembling or making any
adjustments to the equipment.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
This equipment has a spark arresting
1.
muffler included. A spark arresting
muffler is required by law in Califor
-
nia, on some US Forest Service land,
and possibly in other areas or situa-
tions.
Attach the Handle (15) onto the
2.
Frame (18) with the Handle Bolt (16)
and Nut (17).
Attach the Hose (19) to the Hose
3.
Connection on the unit. (See picture
on the next page.)
Pull the Collar at the end of the hose
4.
back and attach the Gun (20) to the
hose.
Screw the Wand (21) onto the Gun
5.
and secure with the grommet.
warning
