Pacific Floorcare S-28HD, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 69

RETURN TO
TABLE OF
CONTENTS
BATTERYSHIELD BATTERYSHIELD
® ®
AUTOMATED WET BATTERY PROTECTION AUTOMATED WET BATTERY PROTECTION
SYSTEM SYSTEM
Scrubbers equipped with BatteryShield® technology have a sensor on the battery pack and a red LED indicator
on the control panel which monitor and communicate low water conditions.
1. When batteries are fully charged and the key is turned on, BatteryShield
®
will check the water level.
•
If the LED remains off, there is sufficient water in the batteries.
•
A solid red LED means BatteryShield
®
senses a low-water level. The brush motor will be
disabled to prevent battery damage.
•
A blinking red LED means the BatteryShield
®
light pipe needs to be cleaned (see below).
NOTE:
Failure to clean the HydroLink
®
light pipe will limit the BatteryShield’s
®
ability to read the water level
and will reduce battery life.
2. Turn the key off and use the HydroLink
®
single-point battery watering system to fill the batteries.
NOTE:
Battery packs equipped with BatteryShield
®
may take
more than 1/2 gallon of water
after the
BatteryShield
®
LED has illuminated.
Failure to pump the HydroLink
™
bulb until it will no
longer compress may result in uneven battery servicing and premature battery failure.
3. After completing the HydroLink
®
watering procedure, cycle the key to verify the LED stays off.
10