Pacific Floorcare S-28HD, Инструкция по эксплуатации и каталог запасных частей

Страница: 11 / 69

RETURN TO
TABLE OF
CONTENTS
SERVICING LEAD ACID BATTERIES WITH HYDROLINK SERVICING LEAD ACID BATTERIES WITH HYDROLINK
® ®
WATERING SYSTEM WATERING SYSTEM
WARNING:
Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals
known to the State of California to cause cancer and reproductive harm, and during charging,
strong inorganic acid mists containing sulfuric acid are involved, a chemical known to the State
of California to cause cancer. Wash hands after handling. For more information go to www.
P65Warnings.ca.gov .
9
1. Position the container of distilled water below the level of the top of the
batteries to prevent siphoning.
2. Place the end of the watering system hose in the distilled water and squeeze
the bulb to fill the system.
3. Remove the dust cover from the Hydrolink
®
snake connected to the batteries.
4. Connect the coupler on the Hydrolink® snake to the coupler on the watering
system using the quick disconnect fittings.
5. While squeezing the hand pump, observe the flow indicator (spinning
red balls). As the batteries begin to fill, the spinning of the flow indicator
balls will slow. Batteries are full when the flow indicators completely stop
spinning.
NOTE
: Battery systems may take more than 1/2 gallon of water once the
BatteryShield
®
light has illuminated. Failure to actuate the hand pump
until the flow indicator stops spinning will result in batteries being under
or unevenly serviced which will reduce battery life.
6. When the flow indicator stops, and not before, immediately disconnect the
couplers by depressing the push button on the watering system coupler.
NOTE
: Leaving the watering system connected could result in the batteries
being over filled. Disconnecting the watering system before the flow
indicator stops spinning will result in batteries being under serviced and
battery life will be reduced.
7. Replace the dust cover on the Hydrolink
®
snake.