Pacific energy UL 1482, Инструкция по установке и эксплуатации

Страница: 7 / 24

SINS.BODYC 230311-20 7
Full Flue Liner - (Required in Canada)
1) Measure the chimney height from the top of the existing fl ue
to the fl oor of the hearth. This will allow extra length of liner
for fl ashing and rain cap.
2) Feed the stainless steel liner from top of the chimney, through
the damper area and into the fi replace cavity. Attach a stove
connector to the bottom of the liner.
3) Remove bay top and both right & left blower covers
(Fig #4 & 6).
4) Remove casing top by removing screws on each casing side
and pulling top forward(Fig. #5).
5) Push insert into fi replace. Use the rear adjustment legs to
level insert. (NOTE: Adjustment legs are located in bottom
rear of insert)
6) Measure, trim and shape a top fl ashing to fi t the existing
chimney fl ue. Plan for a 1” to 1-1/2” overlap on each side.
Place fl ashing over top of the liner and seat fi rmly against
the tile.
7) Caulk around liner with high temp stove cement and insert
into collar. Screw in fasteners to secure.
8) Attach a rain cap to the end of the liner. A storm collar may
be used if desired.
9) Reattach casing top with screws previously removed.
Consult your local Dealer about relining your fireplace
chimney.
Direct Flue Connection
1) Measure from the fi rst chimney fl ue liner tile to the top of the
Insert. Allow extra length of liner to insert into fl ue tile.
2) Feed the stainless steel liner through the damper area and
into the fi rst chimney fl ue tile. Seal around pipe.
Note: A clean-out door may be required under local codes, when
a direct fl ue connection is used. Consult local codes.
3) Remove bay top and both right & left blower covers
(Fig #4 & 6).
4) Remove casing top by removing screws on side and pulling
top forward(Fig. #5).
Chimney
Flue Liner
Fig. # 5
6" Stainless Steel
Rigid or Flex Liner
Mantel or
Top Facing
Direct Flue Connection
Fig. # 3
Fig. # 4
Fig. #6
5) Push insert into fi replace. Use the rear adjustment legs to
level insert.
6) Attach connector pipe to stove collar.
7) Reattach casing top and fasten.
SCREWS
“Wing” Screw