Pacific energy ALDERLEA T6 LE, Инструкции по эксплуатации и монтажу

Страница: 24 / 28

Trouble Shooting
Problem Cause Cure
Excessive Creosote 1) Wood is too wet - Use dry wood
Build-up
2) Turning down air control - Do not turn down until:
too soon a) there is a good bed of coals
b) the wood is charred
3) Draft too low - Chimney plugged or restricted, check flue
- Improper chimney height and/or diameter
- Provide outside air for combustion
- Check draft in chimney and system, alter as
needed.
Glass is Dirty 1) See 1, 2, and 3 above
2) Door Gasket leakage - Replace gasket
- Check door latch
Low Heat Output 1) Wood may be wet - Check wood and use drier wood if required.
2) Fire too small - Build a larger fire
- Open draft control to increase burn rate.
3) Draft too low - Chimney plugged or restricted
Inspect and clean
Won't Burn Overnight 1) Air control set too high - Set control lower
2) Not enough wood - Unsplit wood is preferred for overnight burns
3) Draft too high - Excessive chimney height and/or diameter,
see page 11
Stove Won't Burn 1) Combustion air supply - Check outside air supply for obstructions
is blocked - Check that room air cover is removed.
- Chimney plugged or restricted
Inspect and clean
ALDERLEA T6-LE_260319-28
24 100000087