53
Screw the adjustment barrel 3/4 of the way in, squeeze the pads against the rim, undo
the cable anchor bolt and pull the cable through with pliers. Re-tighten the cable anchor
bolt and apply full force to the brake lever to test, then fine tune using the adjustment
barrel (Fig. 4.6) If one pad is closer to the rim than the other, loosen the fixing nut at the
back of the brake, apply the brake to hold it centered, and re-tighten the fixing nut.
WARNING! Ensure the Brake fixing nut is secured tightly. Failure to do this may
cause the brake assembly to dislodge from the frame or fork and result in
personal injury.
Some brakes have a special mechanism which enables you to set the clearance on either
side of the rim using a screwdriver. Brake pads should finally be adjusted so that the
leading edge of the pad makes first contact with the rim. Some brakes have special
curved washers to allow this, but on less complex models it will be necessary to apply
a little force to the pad and its mounting (Fig. 4.8). (Please refer to page 32-41).
Drivetrain
The drivetrain of a bicycle refers to all parts that transmit power to the rear wheel
including the pedals, chain, chainwheel, crank set, and freewheel.
Pedals inspection
Pedals should be inspected every month, taking note of the following areas:
•
Check correct tightness into the crank arms.
WARNING! If pedals are allowed to become loose, they will not only be
dangerous but will also cause irreparable damage to the cranks.
•
Check that pedal bearings are properly adjusted. Move the pedals up and down, and
right to left, and also rotate them by hand. If you detect any looseness or roughness
in the pedal bearings then adjustment, lubrication or replacement is required.
•
Ensure that the front and rear pedal reflectors are clean and securely fitted.
Lubrication and adjustment
Many pedals cannot be disassembled to allow access to the internal bearings and axle.
However, it is usually possible to inject a little oil onto the inside bearings, and this
should be done yearly. If the pedal is the type that can be fully disassembled, then the
bearings should be removed, cleaned and greased yearly. Because of the wide variety
of pedal types and their internal complexity, disassembly procedures are beyond the
scope of this manual and further assistance should be sought from a bicycle specialist.
MAINTENANCE
Pad should be “toed-in”
0.5 - 1.0 mm
4.8
4.9
53