21
XDL Rover 2 User Guide
Error Codes
The XDL ROVER 2 performs a variety of power-up and run-time tests to ensure optimal
operation. Tests include environmental as well as electrical measurements designed to
avoid damage to the unit while maintaining adequate operation. In the event of an error
condition, the red and blue LED will flash in unison. The LEDs will flash a code indicating
the type of error the unit is experiencing. The table below shows the different error codes
and their corresponding LED flash codes.
LED Blink Rate
(short bursts)
Error Type
What to Do
RX LED on
continuously
External source of interference
inhibiting the XDL ROVER 2 to
receive data
Power cycle the radio to clear error
codes. If an error code persist after
power cycling the radio, contact
customer service.
2
Internal battery charge current
too high.
Check battery, cables, charger, power
supply voltage level, or recharge battery
3
Internal battery charge taking too
long.
Check battery, cables, charger, power
supply voltage level, or recharge battery
4
Unit temperature too high / low.
Operating temperature is above / below
rated levels.
5
Charging temperature too high.
Check battery, cables, charger, power
supply voltage level, or recharge battery
6
Charging temperature too low.
Check battery, cables, charger, power
supply voltage level, or recharge battery
Note: If any problem persists, contact your reseller or Pacific Crest customer support.
Содержание XDL ROVER 2
Страница 1: ...XDL ROVER 2 User Guide...
Страница 24: ...24 XDL Rover 2 User Guide...