- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: [email protected] Web: http://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
NANO 2000T Polisher
NANO 1000T/2000T and 1200T with 1 rpm increments (1 and 1.5 hp motor)
Note:
Do not start or run the motor before the correct input voltage is programmed;
RESET DEFAULT BEFORE REPROGRAMMING
Go to dF → Enter → -def → Enter
Steps to set converter input voltage and frequency response:
Go into Program “U” (Password:0253) → Enter → input “1001” →Enter → input “2042” → Enter
→ input “3050” →Enter→ input “4255” →Display “OVER” →Enter
Go into Program “U” (Password:0253) → Enter → input “1050” →Enter → input “2225” → Enter
→ input “3120” →Enter→ input “4255” →Display “OVER” →Enter
2. Go into Program “nS” (Password:0253) → Enter → input “2” → Enter
3. Go into Program “Sr” (Password:0253) → Enter → input “1.4” → Enter
NOTE: If any of the numbers are entered incorrectly in the above sequence, the process
requires that the default be reset and the program the sequence entered again until it is
exactly correct. THIS IS VERY CRITICAL OTHER WISE AN E01 ERROR CAN OCCUR.
Steps to set converter input voltage and frequency response:
The above settings are for maximum torque which will result is a slight vibration between 240-
280 rpm, to reduce the vibration at the slight loose of torque rest these parameters:
Go into Program “U” (Password:0253) → Enter → input “1001” →Enter → input “2040” → Enter
→ input “3011” →Enter→ input “4050” →Display “OVER” →Enter
Go into Program “U” (Password:0253) → Enter → input “1011” →Enter → input “2050” → Enter
→ input “3014” →Enter→ input “4050” →Display “OVER” →Enter
Go into Program “U” (Password:0253) → Enter → input “1014” →Enter → input “2050” → Enter
→ input “3050” →Enter→ input “4225” →Display “OVER” →Enter
2. Go into Program “nS” (Password:0253) → Enter → input “2” → Enter
3. Go into Program “Sr” (Password:0253) → Enter → input “1.4” → Enter
46
