Pace Technologies MEGA-T400S, Инструкция по эксплуатации

Страница: 12 / 30

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T400S
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
2.3 Installation
(Installation continued on next page)
7
!
Install unit carefully! Improper installation voids warranty.
!
The MEGA - T400S should be placed on a flat stable surface.
Connect the electrical connections
to a 3 - phase power line. The motor driver
max amp draw is 20 amps. However,
the operating power is set to 15 amps.
! Electrical Connections - The standard saw is designed to operate at 208 - 220V 3 - phase
(120V - 120V - 120V - ground) (optional 380V)
Verify voltage on nameplate
!
Connect pump connector, supply line from cutter to the pump and insert the drain hose into
the basket filter
!
Verify the direction of rotation of the cut - off wheel. The wheel should turn from top to bottom
as viewed from the front of the machine. If not reverse any two of the 3 - phase power wires.
Main
Power
switch
Main
Power
Not
used
Coolant
supply
line to
cutter
Electrical
connector
for pump