FEMTO-1100S Polishing Head
I
NSTRUCTION
M
ANUAL
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: [email protected] Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
17
How to Use Auto-Positioning:
1. Loosen the position lock knob
2. Rotate the position lock sleeve to desired location:
a. Grinding- left most position
b. Polishing- right most position
3. Tighten the position locking knob
4. Sling FEMTO head over the working wheel. As long as the head is in the
general area of the set location there will be no issues locating
5. Drop the FEMTO head using the on screen controls
6. The head will adjust to the set position
7. If the head does not drop fully, the FEMTO head was positioned too far from
the acceptable location. Try swinging the head closer to the set position. Use
the below reference image:
Feature Note
:
Green Area is the
allowable drop zone
for the Auto-Position
feature. 10in wheel
have the same drop
zone it is just offset
to one side
