P G . 8
Pacbrake is a registered trademark of Pacbrake Co.
INLINE MOUNT - FORD 6.0L
L5501
8
18
Mount the solenoid valve inside the frame on the passen
-
ger side using one of the air tank fasteners. Drill a ¼" hole
to secure the other side of the solenoid bracket. Install
the ¼" bolt, nut and washers supplied. Connect the nylon
airline from the air tank to the port on the solenoid marked
“IN”. Connect the remaining piece of nylon airline to the
solenoid port marked “CYL”. Now route the other end to
the 90 degree fitting installed in the Pacbrake air cylin
-
der and connect. Secure the airlines with the tie-straps
provided.
19
Connect the air cylinder remote breather hose (blue nylon)
to the barbed fitting on the rod end of the air cylinder. Se
-
cure with a tie-strap. Route the breather end to a clean dry
location in the engine compartment. Secure the hose with
the tie-straps provided.
20
Vehicles without Power Adjustable Pedals
Choose the correct control unit mounting bracket for your
application. Using the 1/4” fasteners provided, secure the
control unit to the mounting bracket with the connector
end pointing down. Loosen the capscrew shown in the
photo for mounting the Pacbrake control unit bracket. In-
sert the Pacbrake bracket between the two factory brack-
ets, then rotate the Pacbrake control unit to attain clear-
ance and tighten the capscrew. Insert the two connectors
of the Pacbrake harness into the control unit.
21
Vehicles with Power Adjustable Pedals
Choose the correct control unit mounting bracket for your
application. Locate the 3 studs shown in the photo by
arrows. Remove all three nuts and install the Pacbrake
control unit mounting bracket over the studs. Re-install the
nuts and tighten.
Insert the two connectors of the Pacbrake harness into
the control unit. Using the ¼" fasteners provided, secure
the control unit to the mounting bracket with the connector
end pointing up.
