Radio Replacement and
Steering Wheel Control Interface
for Toyota / Lexus / Scion Vehicles
RP4.2-TY11
RadioPRO App
Use of the RadioPRO App allows
you to do the following:
•
Configure User Interface Options such
as:
•
Programmable 12v Output
behavior
• Aftermarket radio Parking Brake
Sequencing
•
Factory amplifier settings (Bass,
Mid, Treble, Gain, Fader and
Balance)
• Real Time Fading
• Update Product Firmware
• Read Firmware/Hardware Versions
•
Access Product User Manuals
Trunk -
This selection will provide a 12v+ output on the Red / White wire whenever the ignition is on and the trunk is opened.
Alpine -
If you select the “Alpine” setting on the drop down menu, the Red / White wire will then work in conjunction with the
parking brake output to produce the necessary sequencing for settings menu access. This sequencing is based on the actual
parking brake, meaning to produce this sequence you have to engage the parking brake in the vehicle. If you would like to
manually do the necessary foot brake/parking brake sequencing for Alpine, select the “Foot Brake” setting (if available) and the
Red / White wire will output a 12v+ signal whenever the signal is available and the foot brake is pressed.
Door -
This selection will provide a 12v+ output on the Red / White wire whenever the signal is available and any door on the
vehicle is opened.
Footbrake -
This selection will provide a 12v+ output on the Red / White wire whenever the signal is available and the foot brake
is pressed.
Latched -
This selection will provide a latched 12v+ output that can be tied to any of the vehicles SWC. This means that when
you press the assigned SWC, the Red / White wire will turn on and remain on until the assigned SWC is pressed again or the
ignition is turned off.
Pulsed -
This selection will provide a user programmable timed 12v+ output that can be tied to any of the vehicles SWC. This
means that when you press the assigned SWC, the Red / White wire will pulse for the pre-programmed user time. The range for
pulse time is 100 milliseconds - 25.5 seconds (.1-25.5).
Programmable 12v Output Wire
The Red / White wire can be programmed to do a pulsed or latched trigger that is controlled by a user assigned steering wheel
control button, or it can be set to provide an output when triggered by the vehicles foot brake, door or trunk. Select User Interface
Options then set the behavior of the Red / White wire using the drop down menu. PLEASE NOTE: Available triggers depend on
what info is available on the vehicle’s data bus. Restoring factory settings on the module will default this wire’s output back to a
latched SWC trigger.
PLEASE NOTE:
The interface must be connected to the vehicle when using the following features of the Radio PRO App:
• Programmable 12v Output Behavior
•
Factory Amplifier Settings
The interface does not need to be connected to the vehicle when using the following features of the Radio PRO App:
• Firmware Updates
•
Reading firmware/hardware versions
