Stinger HEIGH10
®
Radio Replacement Kit
2015-2021 Chrysler 300
2015-2021 Dodge Challenger / Charger
SRK-CHR15H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-Audio.com
Pacific Accessory Corporation
Page 34
Rev: V3
Date: 032222
®
Section 6: Radio Unit Installation (ALL VEHICLES) (cont.)
Part Two: Mounting the Radio Module & Interface Assembly
Step 1
Step 2
Step 4
Step 3
Step 5
Step 6
With the display cables routed out
towards the front, position the radio
assembly in place. Checking to
make sure cables and connectors
behind and below the radio are
clear.
Reinstall the four screws
removed from the factory radio
display to secure the assembly in
place.
Chrysler 300:
Reconnect the connector on the
rear of the radio/air vent trim
panel and reinstall.
Chrysler 300:
Reconnect the connector on the
rear of the radio/climate control
panel and reinstall.
Challenger:
Temporarily reconnect the radio/
climate control connector on the
center console panel.
Temporarily plug the two display
cables into the back of the
HEIGH10 display.
Mounting the radio assembly is basically the same for all vehicles. Any vehicle specific differences will be noted.
These final installation steps show temporarily connecting some components and checking radio functions before
reassembling the vehicle and permanently mounting the display screen.
ALL VEHICLES - Proceed to Part 3: Initial Boot Up and Function Tests on next page.
