P.A. SRH10K-24, Руководство пользователя

Страница: 9 / 23

F o r m X X X X : R e v i s e d 2 0 1 8 Page 9
4 Maintenance
4.1 Mechanical
Mandrel
SEQ. MAINT. ITEM REQUIREMENT FREQUENCY-DAYS
1 Jaw Linkage Apply (SAE30) Lube Oil 14
2 Main Shaft Bearing Apply Standard Grease to Fittings 14
Gear Reducer
The reducer requires no periodic maintenance. However, an occasional visual inspection to check for
hardware tightness, leakage and the general overall condition of the reducer is good practice. This reducer is
designed to operate successfully without breather vents. Since the reducer is shipped with lubricant, and
breather plugs are not required, the user is able to eliminate the lengthy preparation normally required to
place a reducer into service.
Drive Chain Maintenance
SEQ. MAINT. ITEM REQUIREMENT FREQUENCY-DAYS
1 Check Chain Tension Adjust as Necessary 30
2 Lubricate Chain Apply Chain Grease 30
At approximately 90 day intervals, or if proper torque is not being maintained, inspect Torque Limiter for
presence of oil, grease, moisture or corrosion on driving surfaces and for proper setting of spring load.
Clean and adjust as required. Friction facings and bushings are the only parts that should normally require
replacement.