background image

Fire Starting Instructions

FOR TIMBER USE

NOTE: The Outback Cooker is designed for outdoor use only. Check local fire regulations in your 
area prior to lighting a fire.

NOTE: Do not overfill the fire chamber with timber or heat beads as this can cause excessive 
smoking. If the cooker has been overloaded and begins to smoke, open the front door to allow 
more oxygen until the timber or heat beads have burnt down.

IMPORTANT: Never leave a fire unattended. Always ensure you have a bucket of water on hand should you 
need to extinguish the fire.

1. Always ensure that the Outback Cooker is set up correctly and in a level position before starting a fire. 
If required, remove any ash from the chamber body. 
2. Place scrunched up newspaper into the chamber body, on top of the fire chamber ash grates.  

Firelighters may be used if required.
3. Place kindling at an angle over the newspaper and light. As the kindling burns, place larger pieces of 

firewood on the fire.
4. Once the fire is established, close the front door and adjust the air vent controls to control the fires 

combustion rate.
5. Open door to add fire wood as required.

CARE INSTRUCTIONS

Chimney Sections and spark arrester

The chimney sections are made from a stainless steel material and will tarnish over time with use.  
Remove the chimney sections and spark arrester regularly and clean with a stiff brush.

Chamber Body and legs

Remove ash build up regularly from the chamber body and under the fire ash grates.

FOR HEAT BEAD USE

1. Always ensure that the Outback Cooker is set up correctly and in a level position before starting a fire. 
If required, remove any ash from the chamber body.
2. Place a firelighter into the chamber body, on top of the fire chamber ash grates.  Light the firelighter 
and surround with half a dozen heat beads.
3. As the heat beads burn, place larger quantities of heat beads on the fire.
4. Once the fire is established, close the front door and adjust the air vent controls to control the fires 
combustion rate.
5. Open door to add heat beads as required.

Содержание Outback Cooker









Отзывы: