4
Step 5 Installing the roof
pole
Select one of the three roof fibreglass poles
and install by sliding it through one of the pole
sleeves that runs side to side across the top of
the tent roof, as indicated in figure 4. Insert the
ends of the roof fibreglass pole into the narrow
opening of the 2-way hubs that are pre-attached
to the tent. Repeat for the remaining roof
fibreglass poles.
Step 1 Choose the site
Select a sheltered camp site protected from the
wind that will not allow water to pond under
the tent Floor. Clear a level area of all stones,
twigs, etc.
Step 2 Lay out the tent
Unpack the contents of your tent. Lay out the
inner of your tent in the direction you wish it to
face. Ensure that you have the door facing in
the direction you desire.
Step 3 Peg down the tent
Peg out the corners of the inner tent. These
peg points are indicated in Figure 1. Anchor
the tent to the ground by inserting the pegs
through the loops around the base of the tent
at an angle of 45 degrees as indicated in Figure
2. Firm but not tight. As you work from one peg
point to the other around the tent base pull the
floor firmly, but not tight.
Step 4 Assemble the poles
Assemble all poles making sure each pole
junction is securely connected. Place the
assembled poles side by side for easy
identification, as indicated in Figure 3.
Assembly Instructions
Figure 1
Figure 2
HELPFUL HINT
1. After unpacking the tent or shelter, use the
check list on page 3 to identify all parts and
make sure all parts are present.
2. It is important to condition your tent or
shelter before use. See page 9 for instructions
Peg Point
Figure 3
HELPFUL HINT
Do not force the pole through the sleeves
as this may damage the sleeve and could
break the pole. Check to ensure the pole
does not snag when sliding it through the
sleeve.
16mm
16mm
203cm
180cm
X6
11mm
149cm
X3
X2
