light will reduce the life of the fabric.
Fading of colour is an early warning
sign. OZtrail products are not designed
as permanent dwellings or structures.
avoid water ponding.
tent/shelter; as mildew and corrosion
can form. Always allow the tent to dry
completely before packing and stowing.
brush or sponge with mild detergent to
with silicon spray.
is provided for easy assembly of the
for any structural reason. The poles
and tent perform perfectly well without
and mishandling may cause failure.
Shock cord is not covered by warranty.
on
page 12.
or does not close. This could be due to
wear or metal fatigue. The problem can
page 15.
and ash burns. This not only blocks the
emergency pole repairs and many
other uses around the camp site.
webbing or corner of the tent as your
remover or the claw of a hammer
hooked under the peg to remove them.
CONDITIONING YOUR NEW TENT
important to condition the tent. Simply
pitch your tent and wet it down with
your garden hose until the fabric and all
seams are saturated. Pay particular
attention to the seams - the thread
swells when wet and blocks the needle
holes. The needle holes also shrink
around the thread. The fabric also
swells into the weave and the
waterproof treatment settles within the
fabric. Let the tent dry completely before
repeating this wetting and drying
process until there is no leakage during
hosing. Always pack your tent away dry.
HELPFUL HINT
MATERIALS:
Pole: Fibreglass and steel
CARE INSTRUCTIONS:
Wipe down all metal surfaces with fresh
soft brush or sponge with fresh water and
mild detergent only and rinse with fresh
clean water. Allow to dry thoroughly.
with silicon spray.
9
PROLONGING THE LIFE OF YOUR TENT