TROUBLESHOOTING
MAINTENANCE
DESCRIPTION OF SYMBOLS
Litres per minute
Kilopascal
Do not expose to rain
Wear hearing & eye protection
Warning
Regulatory Compliance Mark
(RCM)
Double insulated
Warning! The equipment is
remote controlled & may start up
without warning.
V
Volts
bar
kPa
Direct current
psi
n
0
/min
L/min
Pounds per square inch
Unit of pressure
No load speed
Revolutions per minute
Read Instruction Manual
Beware of hot parts
Power tools that are no longer usable should not be disposed
of with household waste but in an environmentally friendly
way. Please recycle where facilities exist. Check with your local
council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse.
For further information, or any parts not listed here,
visit www.ozito.com.au or contact Ozito Customer
Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
WARNING!
BEFORE CLEANING OR CARRYING OUT
ANY MAINTENANCE PROCEDURE, ENSURE THAT
THE BATTERIES HAVE BEEN REMOVED.
Cleaning
• Keep the ventilation slots of the tool clean at all times to ensure efficient
operation.
• After each use, blow air through the tool housing to ensure it is free from
all dust, dirt, etc. Build up of dust or dirt particles may cause the tool to
overheat and shorten the life of the tool.
• If the housing of the tool requires cleaning, do not use solvents. Use of a
cloth only is recommended.
• Never allow any liquid to get inside the tool, never immerse any part of
the tool into liquid.
Storage
When not in use, the tool should be stored in a dry, frost free location, keep
out of children’s reach.
Always disconnect the battery from the tool before storing.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by repair of the tool by an unauthorised person or by
mishandling.
Problem Cause
Remedy
Inflator is
not starting
Battery is low on
charge
Charge battery
Battery not connected
properly
Ensure battery is inserted correctly
Inflator
is not
operating at
full capacity
Possible clogging
Ensure the air inlet is not blocked
when inflating a high volume item.
Ensure the air outlet is not blocked
when deflating a high volume
item.
Loose hose of adaptor Ensure the hose or inflation
adaptor is fitted securely
Motor
stops while
inflating
Battery has no power
Charge battery
High pressure item
has reached preset
pressure.
The inflator will automatically
shut-off when the high pressure
item reaches the preset pressure.
The digital
display is
not working
Power not connected
properly
Ensure the power supply is
connected and the operating mode
switch is in the correct position
Inflating or deflating a
high volume item
The digital display will only
display the current pressure when
inflating a high pressure item.
When inflating a high volume item
the display will show 0.00
