![background image](http://html1.mh-extra.com/html/ozito/work-shed-vac-wvg-951/work-shed-vac-wvg-951_instruction-manual_1666893008.webp)
Hose and Attachments
Insert the smaller end of the hose (7) into the matching vacuum inlet (5) on the
front of the tank body. Secure by pushing and slightly rotating the hose end. Fit the
two extension tubes (1) together then insert the remaining end of the hose into the
larger end of the joined extension tubes (1).
Two attachments have been included:
1 x Crevice nozzle (8)
1 x Floor attachment (9)
These can be fixed to the end of the extension tube by firmly inserting the
extension tube into the matching end of the attachment.
Fitting Floor attachment
Fit the adaptor (10) onto the end of the extension tube (1).
Fit the floor attachment (9) to the adaptor (10).
On/Off Switch (3)
To turn the unit on, press the switch on top of the unit to the “I” setting. To turn
the unit off press the switch to the “0” setting.
Note:
Prior to turning on the unit, always fully unwind the power cord.
Vacuuming Dry Matter
1.
Disconnect the unit from the power supply.
2.
Release the two motor securing clips (2) and lift the motor from the top of the
tank. If the foam filter is assembled to the motors black bracket, remove it. Fit
the cartridge filter (with the rubber seal) over the bracket.
Note:
Do not use the cartridge filter combined with the foam filter.
3.
Ensure the inside of the tank and underside of the motor are both dry.
4.
Fit the motor with the cartridge filter assembled back to the tank and secure in
place by refastening the two motor securing clips (2).
Do not use the foam
filter when dry vacuuming
.
Note:
When vacuuming dry matter always have the cartridge filter assembled.
Failure to do so could cause the motor to fail. Do not use the foam filter when
vacuuming dry matter. Damage caused by incorrect operation will not be
covered under warranty.
If the suction power remains low after emptying the tank the filter may need
to be cleaned.
To clean the cartridge filter, first remove it from the motor bracket. Shake or brush
off excess dirt. Do not use water to clean the cartridge filter, this will prematurely
damage the cartridge filter.
ASSEMBLY (cont.)
7
OPERATION