SAFETY INSTRUCTIONS FOR VACUUM CLEANERS
This appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Recommendations for the use of a residual current device
with a rated residual
current of 30mA or less.
Using an extension lead
Always use an approved extension lead suitable for the power input of this tool. Before
use, inspect the extension lead for signs of damage, wear and ageing. Replace the
extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of an
extension lead not suitable for the power input of the tool or which is damaged or
defective may result in a risk of fire and electric shock.
It is recommended that the extension lead is a maximum of 25m in length. Do Not use
multiple extension leads.
Keep the supply cord dry and out of water.
Do not aim the hose at other persons or animals.
Never pick up asbestos or asbestos dust.
Wood dust and shavings in a confined area can give rise to fire or an explosion.
Guard against possible ignition sources.
Do not pick up any material that is burning or smouldering such as metal grinding
dust, cigarette ends, matches etc.
Never try to move the Vac via the mains lead.
Do not vacuum dry matter without the cartridge filter assembled.
Do not vacuum liquids without the foam filter assembled.
Always switch the unit off before changing attachments, filters and emptying the tank.
Unpack the Work-Shed Vac and all its contents from the carton. Release the two motor
securing clips (2) on the side of the Vac and remove the motor from the tank body.
Remove the components from with in the tank.
Castor Wheels
Place the tank body upside-down on a flat surface. Assemble the castor wheels (6) to
the base of the tank by sliding the bevelled assembly lugs on the wheel assembly into
the wheel assembly points on the base of the tank. Using a Phillips Head screwdriver
(not supplied) secure the wheel assembly with the screw provided by rotating in a
clockwise direction. Repeat for the remaining 3 wheels.
6
ASSEMBLY
!
