PXCPRSK-218U
•
When not in use, the tool should be stored in a dry, frost free location, keep
out of children’s reach.
•
Keep ventilation slots of the saw clean at all times and prevent anything from
entering.
•
If the housing of the saw requires cleaning, do not use solvents. Use of a cloth
only is recommended.
•
Blow out the ventilation slots with compressed air periodically.
•
The blade can be sprayed with light oil to avoid rusting.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the pruning saw by an unauthorised person or by mishandling.
WARNING!:
BEFORE CLEANING YOUR PRUNER OR
CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THAT THE MOTOR IS OFF AND THE
BATTERY REMOVED TO PREVENT ACCIDENTAL STARTING.
MAINTENANCE
TROUBLESHOOTING
Variable speed trigger is locked
Ensure that the safety switch is pressed left or right to enable the trigger to be pressed.
The blade will not insert or remove from the blade
holder
Ensure the blade holder is rotated completely clockwise before trying to insert or remove
the blade.
Saw has cut out during use
The battery may have run out of power and requires charging. If the battery is fully
charged, it is likely that the battery’s thermal voltage protection has been activated. This
can happen when the saw has been used for extended periods.
Place the battery on the charger for an hour. It will need this time to cool down and for the
protection circuits to be reset.
Saw suddenly speeds up
This is normal. Once the saw has started the cut into the timber, based on load, the blade
will speed up to complete the cut.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents. This is normal and
does not indicate a problem.
Cutting Branches Using the Clamping Jaw
Cutting Without the Clamping Jaw
2. Place the branch in
between the clamping
jaws and then lower to
perform the cut.
Note:
The clamping jaw
helps to guide the saw when
cutting round branches up to
Ø
70mm.
1. Ensure the blade and the clamping jaw is secured correctly and hold the saw firmly.
1. Position the bracket
rail of the saw onto the
material to be cut for
stability and then perform
the cut holding the saw
firmly.
When cutting thicker branches (up to Ø90mm) or sawing wood or plastic the clamping
jaws can be removed to prevent them getting in the way of the cut.
6. OPERATION
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long
service life.
The output power automatically cuts off during operation when the tool and/or battery
are placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload, then press
and hold the lock-off button and squeeze the variable speed trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery packs
Note:
The battery protection system does not in any way damage the tool..
Note:
The indicated capacity may be lower than the actual level during use or
immediately after using the tool.
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall outlet.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the charging cradle.
