SETUP & PREPARATION
WARNING!
ENSURE THE BATTERY IS DISCONNECTED
FROM THE TOOL BEFORE PERFORMING ANY OF THE
FOLLOWING OPERATIONS.
CAUTION!
DO NOT HANDLE BLADES WITHOUT GLOVES
AS THEY ARE SHARP AND CAN BECOME HOT AFTER
USE, POTENTIALLY CAUSING PERSONAL INJURY.
3. Insert the cutting blade into the blade holder then release the blade holder
3. Remove the cutting blade from
the blade holder.
3.
2. Rotate and hold the blade
holder as shown.
2. Rotate and hold the blade
holder as shown.
4. Ensure the blade is
secure by pulling on the
blade.
The pruning saw can be fitted with standard reciprocating saw blades, therefore can be
used to cut various timbers and plastics.
Fitting a Cutting Blade
Removing the Cutting Blade
1. Press both sides of the
protective cover and open
it.
5. Close the protective cover
1. Open the protective cover.
4. Close the protective cover
2. CUTTING BLADE
Charging your lithium ion battery - Eco Charger
The tools battery has been shipped in a low charge condition, and requires charging
prior to use. Allow several cycles of charging and discharging (through use of the tool)
for the battery to reach its optimum performance / runtime.
CAUTION:
THE CHARGER FOR THIS PRODUCT
SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).
1. Connect the charger into a mains power outlet.
4. The charger LED will illuminate red signifying that the battery is charging.
5. When removing the charger from
the battery, first press the battery
release tab, then slide the charger
from its position.
2. The charger LED will flash green
showing power is being supplied
to the charger.
3. With the battery sitting on a flat
surface, align the raised ribs on
the battery with the recess in the
charger and slide onto the battery
ensuring a firm connection.
Charger LED Indicator
LED Indicator
Situation
GREEN (Flashing)
Stand By (no battery pack is inserted)
RED (Illuminated)
Battery is charging (low charge)
GREEN (Illuminated)
Battery is fully charged
RED (Flashing)
Battery or Charger fault
RED & GREEN (Flashing)
Battery pack is too hot or too cold (remove battery from
charger and store at room temperature 20ºC. Insert
battery again when at correct charging temperature). If
this happens again, the battery is defective and needs
to be replaced.
Battery Charge Indicator
The purchased battery is equipped with a
battery charge indicator to show the state of
the battery charge.
Press the charge indicator button and look to
see which LED lights.
Note:
The battery needs to be removed from the tool to check the state of charge.
Battery requires immediate charging
Low state of charge, requires charging soon.
Mid state of charge
Full state of charge.
3. BATTERY AND CHARGING
