TROUBLESHOOTING
SPARE PARTS
Problem Cause
Remedy
Blower is not
starting
Battery is low in charge.
Charge battery
Battery not inserted
properly.
Insert battery pack correctly.
Blower is not
operating at
full capacity
Variable speed set low.
Inspect variable speed dial and increase as
necessary.
Motor stops
while blowing
Battery has no power.
Charge battery.
Read the directions for use before operating the tool.
Store the battery only in dry rooms with an ambient temperature
of +10
¼
c to +40
¼
c. Place only charged batteriers in storage (charged
at least 40%).
Keep all other persons away from the danger zone.
Wear goggles and ear muffs.
Safety class III / Safety extra-low voltage.
Safety class II
Do not use the tool in rain
or snow. Do not expose the
tool to wet conditions.
For use in dry rooms only.
DESCRIPTION OF SYMBOLS
• Keep air intake clean and air vents free of debris to avoid overheating the motor.
• Do not use cleaning agents to clean the plastic parts of the tool.
A mild detergent on a damp cloth is recommended. Water must never come into contact with
the tool.
• If the blower vibrates abnormally, stop motor immediately. Abnormal vibration usually indicates
a mechanical problem continued operation could lead to injury or damage.
• No lubrication is necessary as the motor is equipped with lifetime-lubricated bearings.
WARNING!
ALWAYS ENSURE THE TOOL HAS
COMPLETELY STOPPED AND THE BATTERIES ARE
REMOVED PRIOR TO ANY MAINTENANCE.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the repair of
the jet blower by an unauthorised person or by mishandling of the blower. This tool is designed for
DIY use - use in commercial or industrial environments will void the warranty.
MAINTENANCE
Spare parts can be ordered from the Special Orders Desk at your local
Bunnings Warehouse or Homebase store.
For further information, or any parts visit
www.ozito-diy.co.uk or contact Ozito Customer Service:
Great Britain: 0151 294 4488
Ireland: 1850 882711
E-mail: [email protected]
Please note that the following parts of this product are subject to normal or natural wear and
that the following parts are therefore also required for use as consumables.
* Not necessarily included in the scope of delivery!
Category
Example
Wear parts*
Battery
Consumables
Missing parts
SERVICE INFORMATION
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload, then pull the
switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use or immediately
after using the tool.
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall outlet.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the charging cradle.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents. This is normal and
does not indicate a problem.
