4. OPERATING MODES
Before starting to drill or chisel, perform a few simple checks.
Drilling
Hammer Drilling
Chiselling (Free Rotation)
Chiselling (Fixated)
REV
FWD
1 Depress and release the trigger
to ensure it is not locked on.
2 Ensure the workpiece is clamped
and secured where possible.
3 Hold the drill firmly in the
position you want to drill
4 Start the tool and move the tool
into the workpiece.
Note:
Do not force the drill or apply
side pressure. Let the tool do all the
work.
Rotate the mode selector to the drill icon.
This setting is recommended for use when
you desire the accessory to rotate without
hammer action. Ideal for drilling into
timber or steel when correct accessories
for such materials are used.
Rotate the mode selector to the hammer
and drill icon.
This setting is recommended for use
when drilling holes in concrete and other
masonry products. The hammer action will
be in operation while simultaneously the
drill bit rotates.
Rotate the mode selector to the chisel with
rotating arrow icon.
This setting is recommended for use when
you desire a hammer action without the
drill action which is ideal for “chiselling or
chipping” away at masonry products, pick
or chisel accessory bits should be used.
Note:
This mode will allow the drill bit to
rotate freely.
Rotate the mode selector to the chisel
icon.
This setting is recommended for use when
you desire a hammer action without the
drill action which is ideal for “chiselling or
chipping” away at masonry products, pick
or chisel accessory bits should be used.
Note:
This mode will stop the drill bit
rotating completely.
1 For forward rotation, push the
fwd/rev lever towards the left
side of the drill.
2 For reverse rotation push fwd/rev
lever to the right.
1 To start the tool, squeeze the on/
off trigger.
Note:
The further you press the on/
off trigger, the fast the tool will
operate.
2 To stop the tool, release the on/
off trigger.
PXBRHS-200
4. CONTROLS
OPERATION
Forward / Reverse Lever
Operating the Hammer Drill
On / Off Trigger
Mode Selector Dial
