WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
THE BATTERY IS REMOVED BEFORE PERFORMING ANY
OF THE FOLLOWING TASKS.
2. SDS+ ACCESSORIES
3. USING THE DEPTH ROD
The depth rod allows you to drill to a predetermined depth.
Required
Drilling
Depth
a
b
2 While holding the
release button
down, adjust the
depth rod so the
drill bit extends
beyond the end
of the rod to the
required drilling
depth.
4 Drill the hole until
the end of the depth
rod touches the
workpiece.
1 Press and hold the depth rod
release button down and insert
the depth rod into the hole in the
upper handle.
1 Prior to inserting into chuck,
ensure the SDS+ accessory is
clear of dust and debris.
3 Insert SDS+ Accessory into
locking sleeve.
Note:
The locking sleeve should
not be pulled back when inserting
accessory.
5 Pull on the SDS+ accessory to
check it is locked in.
Note:
It should have approximately
10–20mm movement. This is normal.
2 Prior to inserting into drill add
lubricant to the SDS+ accessory.
4 Rotate until accessory is inserted
as far as possible into locking
sleeve.
Note:
You should hear a click when it
is correctly inserted.
6 To remove the SDS+ accessory
pull back the locking sleeve and
pull accessory out.
3 Release the depth rod release
button to secure the depth rod in
position.
Accessory
SDS+
CAUTION:
TO REDUCE THE RISK OF INJURY
WE RECOMMEND THE USE OF GLOVES WHEN
HANDLING DRILL BITS.
