Power tools that are no longer usable should not be disposed of with
household waste but in an environmentally friendly way. Please recycle
where facilities exist. Check with your local council authority for recycling
advice.
Recycling packaging reduces the need for landfill and raw materials. Reuse
of recycled material decreases pollution in the environment. Please recycle
packaging where facilities exist. Check with your local council authority for
recycling advice.
Make sure to shut off the engine, allow the engine to cool before
performing maintenance procedures.
Use a moist cloth to wipe down the pump housing. Allow to dry
thoroughly before storing in a dry location that is protected from bad
weather conditions.
Note:
Ozito will not be responsible for any damage or injuries caused
by repair of the pump by an unauthorised person or by mishandling.
TROUBLESHOOTING
MAINTENANCE
DISPOSAL AND RECYCLING
Problem
Possible Cause
Solution
Unit runs but delivers little or no
water
Leak in suction hose or piping
Clogged suction strainer
Water level above pump intake
Pump not primed
Water level more than maximum lift
Engine speed too low
Tighten suction hoses and use thread sealer.
Clear debris from suction strainer
Lower suction hose into water
Fill pump with water before trying to prime
Move pump closer to water level and increase discharge line length if necessary
Increase throttle
Unit will not start
No fuel
Low quality or deteriorated, old fuel.
Dirty muffler, exhaust
Choke adjusted incorrectly
Air-filter clogged
Fuel evaporation in carburettor (vapour lock) due to
high temperatures
Spark plug is wet or the spark plug electrode is dirty,
placed inadequately or is faulty
Fill engine fuel tank. Refer to engine operating instructions
Use only fresh 91 octane unleaded fuel.
Check and clean
Move choke lever to “OPEN” unless engine is warm. Refer to engine operating instructions
Check, clean or replace filter as required
Wait a 10 to 20 minutes then retry the starting procedure
Refer to the maintenance section on how to remove and inspect
Unit starts but runs and performs
poorly
Air-filter clogged
Choke is still engaged
Engine or carburettor difficulties
Check, clean or replace filter as required
Return the choke to the open position
Contact Ozito customer service
MAINTENANCE CHART
*
Time
Check
*
*
Fuel Tank
Adjust inlet and exhaust valves
Recommended Check & Maintenance Chart
Item
Inspect and tighten all nuts and bolts
Air Filter
Fuel Tank Nozzle
Fuel lines
Spark Plug
Remove carbon in combustion chamber
Every operation / daily
After 20 hours or 1 month
After 50 hours or 3 months
After 100 hours or yearly
(Frequency depends on pump location. i.e. High dust environment every 10 Hrs)
(check for leaks)
(change if neccesary)
(required after first
20 hours / 1 month of use)
Change
Clean
To be performed by qualified service centre
