ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
Sandpaper Selection
Selecting the correct grit of sandpaper is an important step in achieving
optimum results. Coarse grit will remove the most material. Finer grit will
produce a smoother finish. The condition of the workpiece will determine
the grit of the sandpaper to be used. The higher the grit number, the finer
the grade of sandpaper.
If the surface is rough, start with a coarse grit and sand until the surface
is uniform. Medium grit may then be used to remove scratches left by the
coarser grit. Finer grit is then used to finish the surface. Always continue
sanding with each grade of sandpaper until the surface is uniform.
MATERIAL
APPROPRIATE GRIT
Coarse
Sanding
Fine Sanding
Paintwork
180
400
Wood: Softwood
60
240
Hardwood
60
180
Veneer 240
320
Note:
If intermediate sanding is required, choose a grit rating between
coarse and fine. The above table is intended as a guide only. To ensure a
satisfactory result, a small, inconspicuous area should first be tested to
ensure the grit of sandpaper chosen is suitable for the desired finish.
Using Hook & Loop Sandpaper
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Use this method of paper fitment with the supplied sheet of 80 grit
sandpaper. Replacement sanding sheets with hook & loop backing can also
be attached via this method.
1. Align the holes on the
sanding sheet with the holes
on the sanding pad.
2. Press the hook & loop side of
the sandpaper firmly against
the sanding pad.
This tool is compatible with all batteries & chargers from the Ozito Power X Change
range.
CORDLESS 1/3 SHEET SANDER
BATTERY & CHARGER
KNOW YOUR PRODUCT
1. SANPAPER FITMENT
SETUP & PREPARATION
4
6
5
3
1
2
7
8
9
1.
On/Off Switch
2.
Wire Clamp
3.
Palm Grip Handle
4.
Battery Seating
5.
Dust Extraction Port
6.
Dust Extraction Adaptor
7.
Sanding Pad
8.
Sandpaper
9.
Spring Clamp Handle