CARING FOR THE ENVIRONMENT
Tools that are no longer usable should not be disposed of with
household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council
authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito customer service
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
DESCRIPTION OF SYMBOLS
cc
Cubic Centimeters (the standard measure of displacement in Europe and Asia)
n
o
No load speed
/min
Revolutions or reciprocation per minute
dB
Decibel level
Read the manual prior to use
Regulator compliance mark
Wear eye protection
Warning
Pull recoil starter to start motor
Wear ear protection
Fuel inlet
Choke on
Choke off
Regulator compliance mark
40:1 Fuel Oil mix ratio
Keep bystanders away
Extremely hot surface.
110
Sound pressure level
Do not smoke
Do not put hands or feet near
blades when it is running.
8. STORAGE
Storage
In order to avoid deposits forming on the interior of the carburettor,
follow these instructions:
1. Carry out all of the maintenance work and drain the fuel out
of the tank.
2. When the fuel has been drained, start the engine and allow it to
run at idling speed until it stops. This will clean the remainder of
the fuel out of the carburettor.
3. Leave the machine to cool (approx. 5 minutes).
4. Remove the spark plug.
5. Place a teaspoon full of 2-stroke engine oil into the combustion
chamber. Pull the starter cable several times carefully to wet the
internal components with the oil. Fit the spark plug again.
6. Store the machine in a cold, dry place where it is out of the reach
of ignition sources and inflammable substances.
TROUBLESHOOTING
FAULT
POSSIBLE CAUSES
TROUBLESHOOTING
The
machine
does not
start.
Correct starting procedure not
followed.
Follow the instructions
for starting.
Dirty or old fuel mix.
Replace with clean fuel mix.
Dirty spark plug.
Clean the spark plug and
adjust the electrode gap or
fit a new spark plug.
Incorrect carburettor setting.
Contact an authorized
customer service outlet.
The
machine
starts but
does not
develop its
full output.
Incorrect choke lever setting.
Depress throttle to disable
choke.
Dirty or clogged air filter.
Clean the air filter.
Incorrect carburettor setting.
Contact an authorized
customer service outlet.
The engine
does
not run
smoothly
Incorrect electrode gap on the
spark plug.
Clean the spark plug and
adjust the electrode gap or
fit a new spark plug.
Incorrect carburettor setting.
Contact an authorized
customer service outlet.
Engine
smokes
excessively
Incorrect fuel mix.
Use 40 parts fuel to
1 part oil mix.
Incorrect carburettor setting
Contact an authorized
customer service outlet.
