25
MAINTENANCE
Drive Unit
• Keep the ventilation vents of the tool clean at all times, if
possible, prevent foreign matter from entering the vents.
• After each use, blow air through the tool housing to ensure it is
free from all dust particles which may build up. Build up of dust
particles may cause the tool to overheat and fail.
• If the enclosure of the tool requires cleaning do not use solvents
but a moist soft cloth only. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Line Trimmer Attachment
• When not in use, the tool should be stored in a dry, frost-free
location, out of the reach of children.
Replacing the spool & line
1. With the line trimmer attachment upside
down, rotate the bump knob clockwise
(unlock position) with the combination
spanner (19), while holding the spool
housing either firmly by hand (Fig. 35) or
using the large open-end spanner (20).
Note:
Ensure you do not misplace the spring.
2. Remove the empty spool and remove any remaining cutting line
from the spool.
3. Dived 5.5m of 2.5mm cutting line in half
evenly and loop into the spool (Fig. 36)
4. Taking note of the arrow on the spool,
wind on the line, ensure you wind neatly
and in layers. Do not cross the line as
this will stop it from feeding.
WARNING!
! Always ensure that the 4 in 1 garden pack is
switched off and the plug is removed from the power point before
making any adjustments.
Fig. 35
Fig.30
Fig. 36
