Fitting and removing the grass catcher
The catcher must be attached to the two hooks on the
mower (Fig. 9).
1. Lift up the catcher flap (4) with one hand and guide
the catcher (9) with your other hand over the two
hooks on the mower housing (Fig. 10).
2. Lower the grass catcher (9) and allow it to sit in
place. Lower the catcher flap (4).
3. To empty the grass catcher (9), lift the catcher flap
(4) with one hand then lift the grass catcher (9) with
the other hand up off the two raised housing clips.
WARNING!
When assembling the grass catcher (9) back to the mower after
emptying, always ensure there is no build up of grass in the grass chute. If
needing to clear the grass, always ensure the mower is disconnected from the
power supply prior to clearing. A build up of grass in the grass chute may
prevent grass from moving into the grass catcher effectively.
Using the Cord Retainer
The cord retainer prevents the extension cord from
being disconnected during use.
1. Make a loop with the extension cord (socket end
of cord) and push it through the square hole under
the start/stop lever (1) and secure over the hook.
2. Once fitted, connect the lawn mower power plug
into the extension cord socket as shown in
the diagram.
11
ASSEMBLY (cont.)
Fig. 10
Fig. 9
!!
Содержание ELM-300
Страница 1: ......