3
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
Fitting a chain and bar
1. Fully unscrew the side cover
lock by turning it in an anti-
clockwise direction.
2. Remove the side
cover.
3. Fit the chain over the guide bar,
making sure that the cutters are
facing in the direction of rotation.
4. Place the guide bar and chain
in position, ensuring that the
chain is around sprocket wheel
(A). Also ensure that the pin
(B) fits into the guide bar. If it
does not fit, it can be adjusted
slightly with the
chain tensioning
dial. The chain must
not slip off the bar
when you do this.
5. Pull the guide bar
forward until the
chain is closely
seated. Make sure that all the drive links are in the
groove of the bar.
6. Attach the side cover and secure
it with the side cover lock.
NOTE:
Do not fully tighten the side cover lock until
after adjusting the chain tension.
1. Power cord
2. Cord retainer
3. Oil level window
4. Oil tank cap
5. Side cover
6. Chain tensioning dial
7. Side cover lock
8. Guide bar
9. Chain
10. Bucking spikes
11. Chain brake
12. Front handle
13. Lock-off switch
14. On/Off trigger
15. Rear handle
16. Chain bar cover
ELECTRIC CHAINSAW
ACCESSORIES
KNOW YOUR PRODUCT
1. GUIDE BAR & CHAIN
ASSEMBLY
CAUTION!
ALWAYS WEAR GLOVES WHEN HANDLING
THE CHAIN AS IT IS VERY SHARP AND CAN CUT YOU
WHEN IT IS NOT MOVING.
+
+
+
1
3
11
16
8
13
9
15
14
5
4
12
6 7
2
10
+
+
A
B
+
+
WARNING!
ENSURE THE CHAINSAW IS TURNED
OFF & DISCONNECTED FROM THE POWER
SUPPLY BEFORE PERFORMING ANY OF THE
FOLLOWING OPERATIONS.
