Ozito BSR-1000, Руководство по эксплуатации

Страница: 12 / 15

MAINTENANCE
• Regularly empty the dust bag.
• Keep the ventilation slots of the belt sander clean at all times and prevent any
foreign matter from entering.
• If the housing of the belt sander requires cleaning, do not use solvents but a
moist soft cloth only. Never let any liquid get inside the tool. Never immerse
any part of the tool into a liquid.
• After each use blow air through the belt sander to ensure it is free from all
dust particles that may build up. Build up of dust particles may cause the tool
to overheat and fail.
• When the carbon brushes wear out, the tool will stop. The brushes should be
replaced prior to wearing out fully. Brushes will wear out after many uses but
before they do, take the tool to a power tool repairer for a quick and low
cost replacement.
Important:
If the motor on your belt sander operates but the belt does not rotate.
Do not return to the store. Check the drive belt has not been damaged - if it is
damaged or broken please replace.
• To remove and check the drive belt remove the two
screws from the belt cover (Fig. 12).
• If the belt is damaged or worn replace with a new
drive belt and fit onto the turning wheels. Replace
belt cover and screws and your Belt sander is ready
for operation (Fig. 13).
Carbon brushes
When the carbon brushes wear out, the tool will spark and/or
stop. Discontinue use as soon as this happens. They should
be replaced prior to recommencing use of the tool. Carbon
brushes are a wearing component of the tool therefore not
covered under warranty. Continuing to use the tool when
carbon brushes need to be replaced may cause permanent
damage to the tool. Carbon brushes will wear out after many
uses but when the carbon brushes need to be replaced, take
the tool to an electrician or a power tool repairer for a quick and low cost
replacement. Always replace both carbon brushes at the same time.
Note: Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the saw by an unauthorised person or by mishandling of the saw.
11
Carbon brushes
screws
Fig. 12
Fig. 13