12
SPARE PARTS
MAINTENANCE
•
Keep ventilation slots of the grinder clean at all times and prevent any foreign
matter from entering.
•
If the enclosure of the grinder requires cleaning do not use solvents but a moist
soft cloth only.
•
The grease in the gearbox will require replacement / replenishment after extensive
use of the grinder. Please see a qualified electrical repairer to provide this service.
•
Blow out the unit through the rear ventilation slots with compressed air
periodically to ensure a dust free area around the switch.
•
Carbon brushes should be replaced before they wear out. Both carbon brushes
should be replaced at the same time.
•
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents. This is
normal and does not indicate a problem.
•
Excessive sparking visible through the housing air vents and/or the tool
FAILING to operate
May indicate the carbon brushes have worn down and need
to be replaced. Carbon brushes should only be replaced by a
qualified eletrician or power tool repairer.
Replacement carbon brushes can be ordered from Ozito
through your local Bunnings warehouse special orders desk.
Spare part number: SPAGG-0381
NOTE: Ozito Industries will not be responsible for any damage or injuries caused
by repair of the grinder by an unauthorised person or by mishandling of the tool.
Limited spare parts are available subject to availability. Please contact your local
Bunnings Special Orders Desk to order the required spare parts.
Most common spare parts listed below:
Spare part
Ozito part no.
Carbon Brushes (pair)
SPAGG-0541
Inner Flange 40mm
SPAGG-0604
Outer Flange 40mm
SPAGG-0601
Side Handle
SPAGG-0557
Spanner
SPAGG-0556
Power Switch
SPAGG-0546
