MN914
1
MN914
Instruction Manual For Belt Grinder-Buffer
Model 602E-MT
SAFETY NOTICE: WARNING
statements describe conditions that may lead to personnel injury including
potentially fatal injuries if the machine is not properly used and warnings are not properly
followed.
Caution statements describe conditions that may lead to equipment damage.
WARNING:
Do not operate this grinder-buffer until you are sure that you are completely familiar with
the safe operation of the grinder-buffer, all accessories and safety equipment. Improper
use can lead to severe injury. This manual defines proper use of this equipment.
Before using this equipment for any other use, please seek expert advise if you do not
understand any procedure or operation concerning this grinder-buffer or this manual.
WARNING:
Prevent electrical shock hazard and accidental machine operation. Always disconnect
grinder-buffer from the power source before servicing, changing accessories (such as
belt, wire wheel, tool rest, spark arrestor, etc.) or before performing maintenance.
WARNING:
Avoid accidental starting. Make sure switch is in “OFF” position before connecting to
power source.
WARNING:
Be sure the system is properly grounded before applying power. Do not apply power
before you ensure that grounds are connected. Electrical shock can cause serious or fatal
injury. Follow the National Electrical Code (NEC) and local codes for the safe installation
of this equipment.
WARNING:
Always use safety glasses with side shields (or full face shield) when operating grinder.
Do not use ordinary eyeglasses. Also use face or dust mask if cutting operation is dusty.
WARNING:
Unsuitable accessories or attachments added to this machine can create hazards. Baldor
accessories are specifically designed to be used with this grinder-buffer. Use
accessories or attachments only in the proper intended manner. Accessories or
attachments obtained from another source may cause hazards. Consult the manufacturer
before use.
WARNING:
To prevent injury, avoid contact with the wire wheel or belt or disc. The abrasive belt when
running is an aggressive cutting tool. Extra care should be exercised when using coarse grit
belts because of their rapid cutting action. Severe burns or cuts may result from contact.
WARNING:
Keep guards in place and in working order. Guards are design to prevent injury. Never
operate this equipment if a guard is damaged, missing or improperly installed.
WARNING:
Remove adjusting keys and wrenches from this product after use. Check to see that keys
and adjusting wrenches are removed from grinder-buffer before turning it on. Projectiles
can cause severe injury to yourself or others.
WARNING:
Keep work area clean and well lighted. Clutter and poor lighting invites accidents.
WARNING:
Don't use in dangerous environment. Don't use grinder-buffers in damp or wet locations,
or expose them to rain. Electrical shock can cause serious or fatal injury. Follow the
National Electrical Code (NEC) and local codes for the safe installation of this equipment.
WARNING:
Do not wear loose clothing, neckties, rings, bracelets, or other jewelry to get caught in
moving parts. Nonslip footwear is recommended. Wear protective hair covering to contain
long hair.
WARNING:
Secure work. Use clamps to secure the work piece when practical. It's safer than using
your hand and it keeps hands away from wheel or belt.
WARNING:
Check for damaged parts. Before further use, a guard or other part that is damaged should
be carefully checked to assure that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced.
