FIXING THE SCREEN FABRIC TO THE FRAME FOR EVO3D,
ULTRA4K, GREY AND REAR PRO.
See PAGE 8 FOR ACOUSTIC VISION FABRIC ATTACHMENT
1. Put on gloves supplied and place the tube at the end of the frame and unroll over the back of
the assemble frame. The fabric should lay approx 10cm over all edges of the frame.
Once rolled out, adjust so it sits evenly over the back of the frame on all 4 sides.
2. Locate the 4 SCREEN-GRIP lengths.
6
Total of 4 SCREEN-GRIP channels
For Evo3D and Evo Ultra 4K you will normally use the 3rd channel from the inner
edge. For other materials such as Acoustic Vision will use the other outer channels
3 also and 4. Tip: If you find the strips too hard to push in, move to the next outer
.
channel. Do not belt in with a hammer as you may tare the screen fabric and void
your warranty.
Inner channel
Outer channels
Note the hook on the strips.
For best results face this to the inside of the frame
1
2
3
4
Evo4K, grey, rear pro
Acoustic Vision 2K and 4K
Note the black screen grip strip
how it sits on an angle leaning inward.
This is how it’s meant to look.
When inserting the strips, use same
angle to get lip of strip past the opening.
You may tap in with hammer. Do not
bash in as you may tare the material.
You will hear a dull thud sound when it
falls into place.
Inside the hollow of the 2 long frame lengths are
the 4 screen grip strips.
Pull these out before assembling frame.
(the inner 2 are currently not used)
when putting in place.
