9 • Oz Charge manual
www.ozcharge.com.au
TROUBLE SHOOTING
Problem
Indication
Possible Causes Suggested Solution
Charger does not
work?
No Indicator
lights on
- No AC power
- Check AC connections and
make sure the AC Power Point is
switched ON.
- Try a different AC Power Point
which you know is working.
Charger has no DC
output?
Fault Red LED
is ON
- Output is short
circuited
- Reverse polarity
protection
- Loose / bad
connection to the
battery
- Check DC connection between
charger and battery and make
sure they are not short circuited.
(Touching each other)
- Check that the crocodile clips
have not fallen off or come loose.
- Check that the crocodile clips/
ring terminals are connected to
the correct polarity.
Note: The charger output is only
present when connected to a
battery.
No charging current? Fault Red LED
is Flashing
- Battery is severely
sulphated
- Battery has a
damaged cell
- Overheat
protection mode
- Check the battery condition,
age etc.
- Battery may need replacement.
- Move battery & charger to a
cooler environment.
The full / float light
won’t come on.
Fault Red LED
is Flashing
or
Full Green LED
is Flashing
- Battery Ah
capacity too large
for the battery
charger and it has
time out
- Battery is
defective
- Battery is severely
sulphated
- Check the charger
specifications match the battery
capacity. Eg. make sure battery
capacity is not too big for the
charger.
- Battery may need replacement.
- Charge rate selected might be
too low for the battery. Switch
charger off and on and try again
or try a higher charge rate setting
providing it doesn’t exceed the
maximum charge limit for your
battery.
REPLACEMENT PARTS
For the full range of replacement parts and accessories, please visit our website:
www.ozcharge.com.au. / www.ozcharge.co.nz
