Oxford Instruments Cryojet 5 Скачать руководство пользователя страница 4

Страница: 4 / 5

Autofil Set-up

If the system has been ordered with an autofil, the auto-fil should be set-up when the system arrives. The cable from the

solenoid valve connects to the small port at the top of slot 4 (marked Auxilliary) and locks into place.

To check the controller is set-up correctly;

Go to the 2

screen pressing the small arrow at bottom right of touch screen; press OK at the warning screen.

Tap the box showing the Nitrogen level once. This is the top middle box on the first screen

Содержание Cryojet 5

Страница 2: ...the arrows at the top right until you reach the RS232 tab now check the settings i BAUD rate 9600 ii Parity Mark iii Data 8 iii Step 1 iv Flow Control zero IMPORTANT NOTE If you make changes to these settings you MUST hit APPLY before exiting the screen or they will not be saved ...

Страница 4: ...oid valve connects to the small port at the top of slot 4 marked Auxilliary and locks into place To check the controller is set up correctly 1 Go to the 2nd screen pressing the small arrow at bottom right of touch screen press OK at the warning screen Tap the box showing the Nitrogen level once This is the top middle box on the first screen ...

Страница 5: ...low and high fill settings are where you want them They are set to 30 and 90 as standard To change the low and high levels click on the level number value and type in new value with displayed keypad then click ok and home then restart controller Now restart the Mercury ITC controller Trouble Shooting for Agilent Installations Cryojet 5 Agilent Guide ...