Oxford Instruments Cryojet 5 Скачать руководство пользователя страница 3

Страница: 3 / 5

Now scroll to the ISOBUS tab and check that it is set to comm. Port “4” (Or whatever port you are using)

AGAIN you MUST hit “APPLY settings before exiting

Finally on the Settings screen, select “remote access” to be ISOBUS and ensure the second box is “Legacy”

Again apply these settings.

When you now go back to the home screen, using first the home button and then the small arrow

in the LEFT hand side of the screen you should now see that buttons on the bottom row are “greyed out” indicating that you

are in remote mode. You can now also switch between local and remote using the small button at the bottom left of the touch

screen.
After all necessary changes are made, please restart the Mercury controller.

Содержание Cryojet 5

Страница 2: ...the arrows at the top right until you reach the RS232 tab now check the settings i BAUD rate 9600 ii Parity Mark iii Data 8 iii Step 1 iv Flow Control zero IMPORTANT NOTE If you make changes to these settings you MUST hit APPLY before exiting the screen or they will not be saved ...

Страница 4: ...oid valve connects to the small port at the top of slot 4 marked Auxilliary and locks into place To check the controller is set up correctly 1 Go to the 2nd screen pressing the small arrow at bottom right of touch screen press OK at the warning screen Tap the box showing the Nitrogen level once This is the top middle box on the first screen ...

Страница 5: ...low and high fill settings are where you want them They are set to 30 and 90 as standard To change the low and high levels click on the level number value and type in new value with displayed keypad then click ok and home then restart controller Now restart the Mercury ITC controller Trouble Shooting for Agilent Installations Cryojet 5 Agilent Guide ...