3
ON/OFF Switch
• Reset. Operate any of ON/OFF Switch for ten times seconds until the
LED indicator keeps flashing which indicates the in-wall switch has been
restored to default factory settings.
• Adjust brightness. Once the in-wall switch is successfully pair with a
ZigBee LED bulb, you will be able to increase the brightness using the upper
ON/OFF switch, and decrease the level of brigness using the lower ON/OFF
switch.
Get started
3
Warning!
• The in-wall switch must be installed and serviced only by qualified
electrical personnel.
• Do not touch the terminals of the device during testing.
• Turn off all power supplying this equipment before installing.
• Make sure that the power supply is off before connecting or disconnecting
it to the auxiliary device.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors and covers before turning on power to this
equipment.
Failure to follow these instructions will result in death or serious injury.
LED status
What it means
LED flashing
Device has not joined a network
LED Steady
Device has been joined to a network
Red LED
Device OFF
Blue LED
Device ON
LED indicator
The LED status gives the following information:
