11
GB
Setting up the devices
ATTENTION:
First start the outdoor sensor, then the base station.
If possible, do not expose the outdoor sensor or base station to
direct sunlight.
The base station can be hung by the eyebolt
4
or flip out the
stand
6
to place it on a horizontal, level surface.
Starting the outdoor sensor /
changing batteries
Open the battery compartment
12
on the back of the outdoor
sensor by sliding the battery cover
9
in the direction of the arrow.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
12
.
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The signal LED
8
at the front of the outdoor sensor will briefly
light up. The signal LED will then flash about twice a minute,
indicating wireless transmission.
Starting the base station / changing batteries
Open the battery cover
5
at the back of the base station by
pulling up on the tab at the bottom of the battery compartment.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
7
.
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
