OWI INC. ICM6-730SET (All-N-One) CEILING SPEAKERS – INSTALLATION GUIDE
5
INSTALLATION AND WIRING
Remove the rear cover plate, complete with wire strain relief, by loosing the two screws
holding it in place, and sliding the plate off. Once the cover is removed, open the strain
relief fitting by loosening the horizontal screws.
Run the speaker wires through the strain relief opening. After passing about 4 to 6 inches
of wire through the fitting, tighten the screws on the strain relief to secure the fitting and
back plate to the speaker wire. DO NOT over tighten or you may damage the wire jacket,
a snug fit is all that is required.
Tightening onto flexible or hard conduit - The supplied fitting accommodates up to 3/8
inch (9.5mm) flexible conduit. Insert the conduit into the strain relief fitting. Using the
two horizontal screws that clamp the fitting together, clamp the conduit securely between
them. Be sure to leave at least 4 to 6 inches of cable beneath the strain relief fitting.
Step 3 – Expose the input-terminal on the rear of the speaker
