OWI INC. ICM6-730SET (All-N-One) CEILING SPEAKERS – INSTALLATION GUIDE
6
INSTALLATION AND WIRING
Connect the end of the wiring to the removable locking connector that is included with
the speaker by stripping the insulation back about 5mm, inserting the bare end of the wire
into the connector and screwing down the holddown screw until tight. Tighten any
unused screws to avoid vibration.
CAUTION:
ALWAYS USE THE
PROPER FITTING
IN ACCORDANCE
WITH YOUR
AREA'S BUILDING
CODES AND
REGULATIONS
Step 4 – Attach Wiring to the Removable Locking Connector
Using an Alternate Fitting
– the existing strain
relief fitting accommodates many common fitting
requirements. Sometimes, alternate fittings are
required, such as for larger diameter conduit or to
meet specific code requirements.
In these cases, the existing fitting can be easily
replaced with a number of available off-the-shelf
fittings. Simply remove the existing fitting by
unscrewing the two hold-down screws, exposing a
7/8 inch (22mm) knockout hole. Then, install the
alternate fitting.
